Configuration and features:

1.Rear cylinder slider type is a utility model independently developed and produced by our company after years of production practice

Products, acquired.

2.The whole machine consists of six parts: main engine, main control hydraulic station and liquid replenishment station, booster device, pressure relief device, electric control cabinet, etc

Compose.

3.Working cylinder diameter 100--1000mm; Effective depth 400-1500mm or more; Work pressure

300MPa。

4.The frame is a mobile structure.

5. the press frame is in place, due to the mechanical limit limit, the upper piston fixed in the middle of the frame is aligned with the center of the high-pressure cavity. Therefore, the alignment of the piston sealing ring on the high-pressure cavity is very good and it is not easy to damage.

6.The main components of the high-pressure cavity, booster cavity and frame are all strictly calculated pre-strain tension steel wire winding structure, which has light weight, high fatigue strength, long service life, safer and more reliable.

7. The press adopts double media isolation device, which greatly reduces the failure rate and use cost.

8.Fully automatic PLC control, equipped with man-machine interface, truly reflect the actual pressure of the working cylinder. Simple operation and easy maintenance.

9.Equipped with emergency manual pressure relief device to prevent the danger caused by the inability to relieve pressure when the ultra-high pressure pipeline is blocked.

10.Reasonable and optimized hydraulic design and production. The pressure relief speed is adjustable, the pressure relief is slow, the impact is small, the failure rate is low, the operation is simple and the maintenance is convenient.

11.The check valve and pressure relief valve produced by the company have been reasonably optimized and designed, made of alloy materials, and have been tested in practice and have the advantages of safety, reliability and long service life. And apply to get.

Model volume Pressure Mpa control mode

LDJ400/1200—300 Φ400×1200 300 touch screen + PLC

LDJ500/1000—250 Φ500×1000 250 touch screen + PLC

LDJ600/1000—250 Φ600×1000 250 touch screen + PLC

LDJ700/1000—250 Φ700×1000 250 touch screen + PLC

Customized Customized Customized Touch screen + PLC

Cold isostatic press

It is to place the workpiece in a sealed high-pressure vessel, and continuously inject the liquid into the sealed container through the high-pressure booster to achieve a certain high-pressure pressure, so that the workpiece placed in it is subjected to equal pressure in all aspects, so as to achieve the purpose of consistent density and strength of each part of the workpiece.